Transport position and work position of the saw blade
Transport position
- Remove the protective cover (6), remove the table insert (26) and place the riving knife (8) in the bottom position. Reinsert the table insert (26).
- Turn the crank (19) anticlockwise until the teeth of the saw blade (27) lie below the saw table (7).
- Push the saw table expansion (14) in fully.
Push the clamping handle (16) down. This fixes the saw table expansion in place.
Work position
- Position the riving knife (8) in the top position directly over the centre of the saw blade, insert the table insert (26) and fit the protective cover (6).
- Turn the crank (19) clockwise until the top teeth of the saw blade (27) are approx. 3−6 mm above the workpiece.