Starting Operation
- Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
- Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.
Switching On and Off
- Make sure that you are able to press the On/Off switch without releasing the handle.
To switch on the power tool, press and hold the on/off switch (5).
To lock the on/off switch (5) press and hold it while also pushing the lock-on button (6).
To switch off the power tool, release the on/off switch (5). If the on/off switch (5) is locked, press the switch first and then release it.