Starting Operation
- Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
- Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.
Switching On and Off
- Make sure that you are able to press the On/Off switch without releasing the handle.
To start the power tool, push the on/off switch (2) forwards and into the "I" position.
To turn off the power tool, push the on/off switch (2) forwards and into the "0" position.
Preselecting the orbital stroke rate
You can even preselect the orbital stroke rate during operation using the necessary orbital stroke rate preselection thumbwheel (1).
The required orbital stroke rate is dependent on the material and the work conditions and can be determined using practical tests.