Adjusting mitre angles
Setting Standard Mitre Angles (see figure I)
For quick and precise setting of commonly used mitre angles, detents are provided on the saw table:
Left | Right |
|---|---|
0° | |
45°; 30°; 22.5°; 15° | 15°; 22.5°; 30°; 45° |
- Loosen the locking knob (15) if it is tightened.
- Pull the lever (16) and rotate the saw table (12) left or right to the required detent.
- Release the lever again. The lever must be felt to engage in the detent.
- Retighten the locking knob (15).
Setting any Mitre Angle
The mitre angle can be set between 47° (left-hand side) and 47° (right-hand side).
- Loosen the locking knob (15) if it is tightened.
- Pull the lever (16), turn the saw table (12) left or right by the locking knob and set the required mitre angle using the angle indicator (17).
- Retighten the locking knob (15).