Preparing for operation

To ensure precise cuts, the basic settings of the power tool must be checked and adjusted as necessary after intensive use.
Experience and suitable special tools are required for this.

A Bosch after-sales service point will handle this work quickly and reliably.

The free end of long workpieces must have something placed underneath it or be supported.

The saw table can be extended left and right using the extension bar (21).

  • Loosen the clamping screw (13).
  • Pull out the extension bar (21) to the required length.
  • Retighten the clamping screw (13) to fix the extension bar.

You have to move the adjustable fence (23) to saw bevel angles.

  • Loosen the wing bolt (43).
  • Pull the adjustable fence (23) all the way out.
  • Retighten the wing bolt (43).

After sawing the bevel angles, slide the adjustable fence (23) back again (loosen the wing bolt (43); slide the fence (23) all the way in; retighten the wing bolt).

To ensure maximum safety while working, the workpiece must always be firmly clamped.
Do not saw workpieces that are too small to clamp firmly.

  • Press the workpiece firmly against the fences (11) and (23).
  • Insert the supplied screw clamp (22) into one of the corresponding holes (35).
  • Loosen the wing bolt (44) and adjust the screw clamp to the workpiece. Tighten the wing bolt again.
  • Tighten the threaded rod (45) to fix the workpiece in place.

Releasing the workpiece

  • To loosen the screw clamp, turn the threaded rod (45) anticlockwise.