Checking and Adjusting the Basic Settings

To ensure precise cuts, the basic settings of the power tool must be checked and adjusted as necessary after intensive use.
Experience and suitable special tools are required for this.

A Bosch after-sales service point will handle this work quickly and reliably.

Aligning the fence

  • Bring the power tool into the transport position.
  • Turn the saw table (12) to the 0° detent . The lever (16) must be felt to engage in the detent.
  • Pull the adjustable fence (23) all the way out.

Checking (see figure P1)

  • Set an angle gauge to 90° and position it flush with the saw blade (41) between the fence (11) and the saw blade on the saw table (12).

The leg of the angle gauge must be flush with the fence over the complete length.

Setting (see figure P2)

  • Loosen all hex socket screws (48) with the hex key (32) provided.
  • Rotate the fence (11) until the angle gauge is flush over the complete length.
  • Re-tighten the screws.

Aligning the mitre angle indicator (see figure Q)

Checking

The angle indicator(17) must be in line with the 0° mark of the scale (18).

Setting

  • Loosen the screw (49) using a cross-headed screwdriver and align the angle indicator along the 0° mark.
  • Retighten the screw.